Filter Technologies has a large selection of pleated filter cartridges to meet the most stringent filter requirements, including final filtration of parenteral drugs.

Our membranes are available in General Grade, Beverage & Electronic Grades, Pharmaceutical Grade, and a "Water Grade". All filters are rinsed for purity and tested to assure integrity.

Our high-retention pleated microfiber medias have one of the highest retention efficiencies. These nominally rated cartridges are one of the best values available. Ideal for OTC medicines where a membrane is not required, our polypropylene and microglass cartridges are also rinsed and tested according to grade specification. Our application experience includes mouthwash, cough sryup, & decongestants among others.

Filter Technologies, Inc.

Industrial Filtration & Separation Products

Polyethersulfone Membrane- While different grades are available, our flagship general grade Polyethersulfone cartridges (GPS) are designed for general purpose use wherever a cost effective membrane filter is required. Designed to hold the maximum amount of filter media that can be completely and effectively utilized in a cartridge, GPS filters lower the cost of filtration .

GPS cartridges are flushed with 17+ megohm-cm water to remove potential extraneous manufacturing debris. Ideal for high purity water final filtration on basic DI water systems.

General Grade PES ---Beverage Grade---Pharmaceutical Grade---Electronics Grade---WaterGrade

Nylon Membrane- Our Nylon membrane is typically used where PES would be incompatiable. Nylon has a higher termperature rating, and when combined with High Temp structural componets, the cartridge is safe to use at up to 250 degrees F.

GNM cartridges are flushed with 17+ megohm-cm water to remove potential
extraneous manufacturing debris. These cartridge modules are also individually tested. Priced below special purpose cartridges, GNM cartridges are still manufactured with the same careful attention to both quality and performance.

General Grade Nylon---Beverage Grade---Pharmaceutical Grade---Electronics Grade

Polypropylene Membrane - great for solvent filtration. Absolute rated at 0.1 and 0.2 microns, the hydrophobic nature of the membrane enables it to be used as a vent filter or for purifying gases. Often used in place of PTFE Membrane because of lower cost and no undesirable extractables. PTFE, however, is best for vent filtration.

GPM cartridges are flushed with 17+ megohm-cm water to remove potential extraneous manufacturing debris. These cartridge modules are also individually tested. Priced below special purpose cartridges, GPM cartridges are still manufactured with the same careful attention to both quality and performance.

General Grade Polypropylene---Beverage Grade---Pharmaceutical Grade---Electronics Grade

Contact Information
Filter Technologies, Inc.
168 Manalapan Road, Spotswood, NJ 08884

Phone: 732-251-9500 Fax: 732-251-9503

E-mail Inquires: contact us